Cisco Ultra-Reliable Wireless Backhaul Standalone, Software Configuration Guide, Release 26.1.x

PDF

Cisco Ultra-Reliable Wireless Backhaul Standalone, Software Configuration Guide, Release 26.1.x

Configure RTS mode from CLI

Updated: April 10, 2026

Want to summarize with AI?

Configure ready to send (RTS) mode settings on dot11radio interfaces using CLI commands.

Configure RTS mode to control ready to send protection on wireless interfaces, either by disabling RTS protection or enabling it with a specific threshold value.

RTS mode configuration allows you to manage wireless transmission protection mechanisms on dot11radio interfaces.

Procedure

	1.	To disable ready to send (RTS) mode, use the following CLI command: Example: `Device# configure dot11radio <interface> rts <disable>`
	2.	To enable RTS with threshold value, use the following CLI command: Example: `Device# configure dot11radio <interface> rts enable <threshold>` The threshold range is from 0 to 2346.

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Configure RTS mode from CLI

Procedure

Example:

Example: