Cisco Ultra-Reliable Wireless Backhaul Standalone, Software Configuration Guide, Release 26.1.x

PDF

Reset the device to factory default using CLI

Updated: April 10, 2026

Want to summarize with AI?

Log in

Resets the device to factory default.

Reset the device to factory default to revert all device configuration SETTINGS, including the device IP address and administrator password, to factory defaults.

To reset of the device configuration, use the following CLI command:

Procedure

1.

Use the configure factory reset config command to reset of the device configuration.

Example:

Device# configure factory reset config
WARNING: "configure factory reset config" will clear config and reboot.
Do you want to proceed? (y/n)

Enter y in the CLI command to start the device reset process or alternatively enter n to abort the process.
2.

Use the configure factory reset default command to reset the device configuration and data wipe.

Example:

Device# configure factory reset default
WARNING: "configure factory reset default" will take minutes to perform DATA WIPE.

Example:

The following files are cleared as part of this process:


1) Config, Bak config files
2) Crashfiles
3) syslogs
4) Boot variables
5) Pktlogs
6) Manually created files
Do you want to proceed? (y/n)

Enter y in the CLI command to start the device reset of the configuration and data wipe or alternatively enter n to abort the process.