Guides through the initial setup and configuration of network units in provisioning mode, including factory resets, reboots, and console port connections.
Initial configuration of devices in provisioning mode
Describes the provisioning mode configuration process for Catalyst IW Access Points running in URWB mode.
Provisioning mode behavior
Lists provisioning mode defaults, connectivity requirements, addressing behavior, and CLI output examples.
Verify provisioning mode using GUI
Verifies whether the device is in provisioning mode.
Verify provisioning mode using CLI
Verifies if the device is in provisioning mode.
Configure the fallback address
Configures a fallback static IPv4 address, subnet mask, default gateway, and optional DNS servers so the device remains reachable if it does not receive an IP address from DHCP.
Troubleshoot connectivity
Troubleshoot connectivity by checking network cabling, DNS, required cloud domains, HTTPS access, and fallback IP settings in provisioning mode.
Reset the device to factory default using GUI
Configure the device to reset to factory default SETTINGS using the GUI interface.
Reset the device to factory default using CLI
Resets the device to factory default.
Reboot the device using GUI
Configure the device to restart its operating system using the GUI interface.
Save and RESTORE the device SETTINGS
Configure device SETTINGS MANAGEMENT by saving current configurations as backup files and restoring saved configurations to devices.
Configure GENERAL SETTINGS
Configure GENERAL mode SETTINGS and LAN parameters for mesh network devices.
Connect to the access point console port
Configure the access point locally by connecting to the console port and accessing the CLI.