Cisco Ultra-Reliable Wireless Backhaul Standalone, Software Configuration Guide, Release 26.1.x
Is this content helpful?
Thank you for your feedback. Your response has been recorded.
AI responses are currently only available to logged in users. Log in
Important. Results generated by AI. Before using results, verify accuracy and completeness.
Only ask questions about this document. To ask questions about this product as a whole, go to Technical Documentation .
Suggestions
Sorry, we couldn't generate a response for this query.
Launch error. Something went wrong. Please try again.
Updated: April 10, 2026
Want to summarize with AI?
Log inImportant. Results generated by AI. Before using results, verify accuracy and completeness.
Deletes a specific NAT rule on an access point using the configure ip NAT entry del command through the command line interface.
This task deletes a specific NAT rule on the AP.
Use the configure ip nat entry del command to delete the specific NAT rule on the AP. Example: |
Need help?
(Requires a Cisco Service Contract)
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.