Cisco Ultra-Reliable Wireless Backhaul Standalone, Software Configuration Guide, Release 26.1.x

PDF

Configure IW Service Cluster from CLI

Updated: April 10, 2026

Want to summarize with AI?

Configure the IW Service cluster settings on an access point using CLI commands.

This task allows you to configure the cluster settings for IW Service to optimize service connectivity based on geographical region.

You can configure the cluster setting to automatically select the optimal cluster or manually specify a regional cluster (US or EU) for your access point deployment.

Procedure

To configure the IW Service cluster in an AP, run the following command:

Device#iw- cluster{ auto| US| EU}

Note

By default, the auto option is enabled.

After you configure the AP with the required cluster, use the following URL to access the IW Service.

For auto use: device.ciscoiot.com
For the US, use: US.ciscoiot.com
For the EU, use: EU.ciscoiot.com

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.