Provides the LED patterns for the Catalyst IW9167E access point during the booting process and operational states.
The Catalyst IW9167E follows specific LED patterns during the booting process and operational states to indicate system status and signal quality.
| Events |
LED State |
|---|---|
| Boot loader status sequence: DRAM memory test in progress DRAM memory test OK Board initialization in progress Initialization FLASH file system FLASH memory test OK Initializing Ethernet Ethernet OK Starting AP OS Initialization Successful |
Blinking green |
| When you press the reset button for less than 20 seconds |
Blinking red |
| When you press the reset button for more than 20 seconds |
Solid red |
| When reset button is released Or When you press the reset button for more than 60 seconds |
Blinking green |
Once the access point boots up, the Catalyst IW9167E follows these below LED patterns:
| AP State |
LED State |
|---|---|
| General warning: Insufficient inline power |
Cycling through red, green, and amber |
| Provisioning mode: Fallback |
Blinking amber |
| Provisioning mode: DHCP |
Amber |
| SNR(Signal to Noise Ratio) Excellent (>=25 dB) | Blinking green |
| SNR Good (15<=X<25 dB) |
Fade-in green |
| SNR Bad (10<=X<15 dB) |
Fade-in amber |
| SNR Unbearable (<10 dB) |
Fade-in red |