Cisco Ultra-Reliable Wireless Backhaul Standalone, Software Configuration Guide, Release 26.1.x

PDF

Multicast

Updated: April 10, 2026

Guides users through configuring and managing multicast networking features using both graphical and command-line interfaces, including verification and deletion procedures.

Multicast

Describes a communication method where data is sent from one source to multiple destinations simultaneously.

Configure Multicast using GUI

Configure Multicast routing on mesh end devices using the web-based GUI configurator.

Configure multicast using CLI

Configure multicast groups using CLI commands to add destination IP addresses for upstream and downstream traffic flow.

Delete multicast using CLI

Configure the system to remove a meshID IP address from a multicast group using CLI commands.

Verify multicast configuration using CLI

Provides information on viewing the status of multicast configuration using CLI commands.

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.