Configure the operating channel for Cisco Catalyst IW9167E, IW9165D, and IW9165E access points in 4.9 GHz frequency band using CLI commands.
Configure the operating channel for wireless devices to operate in the 4.9 GHz frequency band with URWB mode support.
From UIW Release 17.15.1, the Cisco Catalyst IW9167E, IW9165D, and IW9165E AP supports 4.9 GHz frequency band in URWB mode for -Q domain (Japan). When operating at 4.9 GHz frequency band, the device supports only 20 MHz channel bandwidth.
The -Q domain supports 802.11ax rates when operating in 4.9 GHz.
| Channel number |
Frequency (MHz) |
|---|---|
| 184 |
4920 |
| 188 |
4940 |
| 192 |
4960 |
| 196 |
4980 |
Procedure
| 1. | Use the configure dot11Radio interface command to configure the wireless device with radio interface number. Example:The valid values are 1 and 2. |
|
| 2. | Use the configure dot11Radio interface channel channel-id command to set the operating channel id. Example:The valid range for the channel is 1 to 256. |
|
| 3. | Use the end command to return to privileged EXEC mode. Example: |