Cisco Ultra-Reliable Wireless Backhaul Standalone, Software Configuration Guide, Release 26.1.x

PDF

Cisco Ultra-Reliable Wireless Backhaul Standalone, Software Configuration Guide, Release 26.1.x

Configure static IPv6 address without eui-64, gateway, and DNS server address

Updated: April 10, 2026

Want to summarize with AI?

Configure the static IPv6 address without eui-64, gateway, and DNS server address on the AP.

This task configures a static IPv6 address without eui-64, gateway, and DNS server address on the access point.

Use this configuration when you need to manually assign IPv6 network settings to an access point without using the eui-64 interface identifier format.

Procedure

Use the configure ap address ipv6 static ip command to configure the static IPv6 address without eui-64, gateway, and DNS server address on the AP.

Example:

Device# configure ap address ipv6 static fc00::1234:5678:xxxx:def/64 fc00::1 2001:4860:4860::xxxx 2001:4860:4860::xxxx

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.