Cisco Ultra-Reliable Wireless Backhaul Standalone, Software Configuration Guide, Release 26.1.x

PDF

Cisco Ultra-Reliable Wireless Backhaul Standalone, Software Configuration Guide, Release 26.1.x

Validate point to point relay topology from CLI

Updated: April 10, 2026

Want to summarize with AI?

Log in

Lists commands and output examples for validating point-to-point relay topology configuration.

To validate point-to-point relay topology configuration, use show commands to verify interface settings and wireless parameters across mesh devices.

Use the show dot11Radio interface config command to validate the configuration:

Mesh End (ME) Statistics

Device# show dot11Radio 2 config
Interface : enabled
Mode : fixed infrastructure
Frequency : 5180 MHz
Channel : 36
……
Passphrase : Cisco
AES encryption : enabled
AES key-control : enabled

Mesh Point (MP1) Statistics

Device# show dot11Radio 1 config
Interface : enabled
Mode : fixed infrastructure
Frequency : 5180 MHz
Channel : 36
……
Passphrase : Cisco
AES encryption : enabled
AES key-control : enabled
Device# show dot11Radio 2 config
Interface : enabled
Mode : fixed infrastructure
Frequency : 5745 MHz
Channel : 149
……
Passphrase : Cisco
AES encryption : enabled
AES key-control : enabled

MP2 Statistics

Device# show dot11Radio 1 config
Interface : enabled
Mode : fixed infrastructure
Frequency : 5745 MHz
Channel : 149
……
Passphrase : Cisco
AES encryption : enabled