Describes NAT support for AGV data flows, including NAPT, SNAT, port assignment, rule configuration, deletion, and verification of NAT translations.
Network address translation
Explains the NAT feature that ensures smooth and efficient roaming for Automated Guided Vehicles by using a single public IP address for AGVs to access the outside network.
Downstream data flow using NAPT for AGVs
Describes the flow of data from the outside network to the AGV's inside network using NAPT.
Assign port numbers using NAPT for AGVs
Lists the reserved outside port numbers for NAPT configuration and the services they support for AGV communications.
NAPT rule on AP
Describes a network address and port translation rule that directs data flow to specific ports on inside hosts.
Upstream data flow using SNAT for AGVs
Describes the process of data transmission from inside network to outside network through access points using Source Network Address Translation.
Configure NAPT using CLI
Configure NAPT functionality to enable downstream data flow on the AP using CLI commands.
NAPT configuration example
Describes the configuration of Network Address Port Translation to enable address translation and port mapping. This reference provides the necessary commands to allow multiple internal devices to share a single external IP address.
Configure SNAT using CLI
Configure SNAT functionality to enable upstream data flow on the AP using command line interface commands.
SNAT configuration example
Describes the configuration of SNAT to enable network address translation between inside and outside network parameters. This reference provides the necessary commands to establish translation for internal devices accessing external networks.
Delete NAT rule using CLI
Deletes a specific NAT rule on an access point using the configure ip NAT entry del command through the command line interface.
Delete all NAT rules
Deletes all NAT rules on an access point using the CLI. This procedure removes existing NAT configurations from the device.
Verify NAT configuration using CLI
Provides the command to check the status of NAT configuration on a device.
Verify NAT translations using CLI
Provides the CLI command output for verifying NAT translations on a device.