Guides users through configuring radio frequencies, channel bandwidth settings, and validation procedures across different regional frequency bands including specialized configurations for US, Canada, and Great Britain.
4900-4990 MHz frequency support for US and canada with license enforcement
Lists the 4.9 GHz frequency bands supported by Cisco Catalyst IW9167E, IW9165D, and IW9165E APs for Canada and United States domains.
5855-5935 MHz frequency support
Describes the Intelligent Transport Systems frequency band allocated in Europe to support ITS applications.
Enabling 5855-5935 MHz frequency bands
Describes how to configure the 5.9 GHz frequency band using the IW Service in either Cloud-Managed or Offline Deployment mode.
Configure operating channel and bandwidth using CLI
Configure the operating channel and bandwidth for a dot11Radio interface using CLI commands.
Validate operating channel and bandwidth using CLI
Provides CLI command to validate radio channel and bandwidth configuration parameters on wireless devices.
Configure operating channel and bandwidth using GUI
Configure the operating channel and bandwidth for wireless radio SETTINGS through the graphical user interface.
UNII-3 band with DFS support
Provides information about Dynamic Frequency Selection (DFS) and UNII-3 band support across different regions.
Configure operating channel using CLI
Configure the operating channel for Cisco Catalyst IW9167E, IW9165D, and IW9165E access points in 4.9 GHz frequency band using CLI commands.
Configure channel bandwidth from CLI
Configure channel bandwidth settings for radio interfaces using CLI commands.
Validate operating channel and bandwidth from CLI
Provides the CLI command to validate radio channel and bandwidth configuration.
Configure radio channel and bandwidth from GUI
Configure radio channel and bandwidth using the GUI by setting the operating channel ID, radio mode, and frequency range.
Configure VLAN SETTINGS
Configure VLAN SETTINGS to connect the access point to a VLAN that is part of the local wireless network.
Rules for packet management
Lists the classification rules for incoming and outgoing data packets based ON parameter values.
Configure Fluidity using GUI
Configures Fluidity mode on a wireless radio using the GUI. This procedure enables specific unit roles and settings for infrastructure or vehicle-based wireless communication.
Configure fluidity using CLI
Configure Fluidity mode on radio interfaces using CLI commands to enable the desired Fluidity role.
Configure fluidity coloring
Configure fluidity coloring to enable wayside or outside devices (Fluidity infrastructure devices) to be given specific color codes to enhance or drive the handoff process.