Introduces IPv6 networking concepts, address types, and limitations, then guides through configuring and verifying IPv6 settings using both command-line interface and graphical user interface methods.
IPv6 Support
Describes IPv6 address support for APs starting from UIW Release 17.15.1, including how the service is disabled by default and can be enabled through CLI or GUI configuration.
IPv6 address types
Describes the IPv6 address types that can be configured on an AP.
IPv6 limitations on the AP
Describes the IPv6 limitations on access points, which support only host functionality while the Fluidity Layer 3 network lacks IPv6 support.
Enable or disable IPv6 using CLI
Configure IPv6 support on the AP using CLI commands.
Enable or disable IPv6 RA autoconfig using CLI
Configure IPv6 RA autoconfig settings on an access point using CLI commands.
Configure static IPv6 address with eui-64, gateway, and DNS server address
Configure a static IPv6 address with eui-64, gateway, and DNS server address on the AP.
Verify static IPv6 address with eui-64, gateway, and DNS server address
Provides the command to verify the static IPv6 address with eui-64, gateway, and DNS server address on the AP.
Configure static IPv6 address without eui-64, gateway, and DNS server address
Configure the static IPv6 address without eui-64, gateway, and DNS server address on the AP.
Verify static IPv6 address without eui-64, gateway, and DNS server address
Provides verification command for static IPv6 address configuration without eui-64, gateway, and DNS server address on the AP.
Configure static IPv6 address with EUI-64
Configures a static IPv6 address with EUI-64 format on an access point using the configure AP address ipv6 static command with the eui-64 parameter.
Verify static IPv6 address with eui-64
Provides the command to verify the static IPv6 address with eui-64 on the AP.
Configure static IPv6 address without eui-64
Configures a static IPv6 address on an access point without using EUI-64 format by specifying the complete IPv6 address manually.
Verify static IPv6 address without eui-64
Provides the command to verify the static IPv6 address without eui-64 on the AP.
Clear the IPv6 gateway and DNS servers configuration
Configure the AP to clear IPv6 gateway and DNS servers addresses.
Verify the cleared IPv6 gateway and DNS servers configuration
Provides the command to verify the cleared IPv6 gateway and DNS server addresses configuration on the AP.
Enable and configure static IPv6 using GUI
Configure static IPv6 SETTINGS through the URWB configurator GUI interface.
Verify static IPv6 using GUI
Verifies static IPv6 configuration through the graphical user interface by navigating to MANAGEMENT SETTINGS and reviewing the DEVICE SETTINGS section. This process confirms that the IPv6 address details are correctly applied to the device.