Covers URWB radio mode configuration, including radio state, frequency, modulation, spatial streams, RTS, WMM, NTP, and validation using CLI and GUI.
Configure URWB radio mode
Lists the radio mode configurations for wireless interfaces operating in Fixed infrastructure or Fluidity mode.
Configure radio-off mode from CLI
Configure radio-off mode when both radios (Fluidity and fixed) are disabled using CLI commands.
Configure radio mode for URWB from CLI
Configure the operating function of the wireless interface to select between Fluidity, fixed infrastructure, or Fluidmax modes.
Configure AMPDU using CLI
Configure an Aggregated MAC Protocol Data Unit's (AMPDU) length and priority using CLI commands.
Configure frequency from CLI
Configure an operating frequency using CLI commands.
Configure maximum modulation coding scheme index from CLI
Configure maximum modulation coding scheme (MCS) index using CLI commands.
Configure maximum number of spatial streams index from CLI
Configure the maximum number of spatial streams (NSS) index using CLI commands.
Configure Rx-SOP threshold from CLI
Configure receiver start of packet (Rx-SOP) threshold using CLI commands.
Configure RTS mode from CLI
Configure ready to send (RTS) mode settings on dot11radio interfaces using CLI commands.
Configure WMM mode from CLI
Configure wireless multimedia (WMM) mode using CLI commands to set class-of-service parameters and manage wireless statistics counters.
Configure NTP from CLI
Configure NTP server settings, authentication, timezone, and service status using CLI commands.
Configure NTP using GUI
Describes how to configure Network Time Protocol (NTP) settings using the graphical user interface. This method provides a visual way to synchronize device clocks with network time servers.
Validate radio mode for URWB
Provides show commands to validate Radio mode for URWB and configuration steps to change Radio mode.
Configure radio-off mode using GUI
Configure Radio-off mode by choosing either Fixed or Fluidity mode and selecting mesh end mode for Catalyst IW9167E access points at the head end.
Configure Radio mode using GUI
Configure the operating mode for Radio interfaces to establish wireless connections between devices with matching frequencies.