Cisco Ultra-Reliable Wireless Backhaul Standalone, Software Configuration Guide, Release 26.1.x

PDF

Configure fluidmax frequency scan using CLI

Updated: April 10, 2026

Want to summarize with AI?

Log in

Configure Fluidmax frequency scan on the device using CLI commands.

Configure Fluidmax frequency scan settings to enable automatic frequency scanning and to set appropriate threshold values. This ensures optimal wireless performance.

Fluidmax frequency scan allows the device to automatically scan for better frequencies when the signal quality falls below a specified threshold. This feature helps maintain optimal wireless connectivity in dynamic environments.

Procedure

1.

Use the configure dot11Radio slot numbermode fluidmax automatic-scan enable command to enable the Fluidmax frequency on the radio.

Example:

Device# configure dot11Radio 1 mode fluidmax automatic-scan enable
Note

Use the configure dot11Radio slot numbermode fluidmax automatic-scan disable command to disable the Fluidmax frequency on the radio.
2.

Use the configure dot11Radio slot numbermode fluidmax threshold value command to set the threshold value for Fluidmax frequency scan.

Example:

Device# configure dot11Radio 1 mode fluidmax threshold 90

  • he valid Fluidmax threshold values range from 0 to 100.

  • If auto-scan is enabled, the system triggers a scan when the signal from the master falls below the specified threshold value.