The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
FIPS certification is a compliance mode that ensures SSH and GUI functionalities comply with FIPS140-3 security standards from NIST. When enabled, it also ensures that the AP configuration meets FIPS requirements.
 Note |
FIPS certification does not support SNMP. |
This task configures FIPS mode on an access point.
|
Use the configure fips { enable | disable } command to enable or disable FIPS mode on AP. Example: |
|
Use the show fips command to verify FIPS mode on the AP. Example: |
Feedback