Configuration Guide for Cisco Optical Site Manager, IOS XR Release 26.x.x

PDF

Configuration Guide for Cisco Optical Site Manager, IOS XR Release 26.x.x

Manage Raman interface parameters

Updated: October 14, 2026

Want to summarize with AI?

Log in

Use this procedure to manage Raman interface parameters in Cisco Optical Site Manager. Use it to complete the workflow and verify the result in the related Cisco Optical Site Manager page.

Use this task to manage Raman interface parameters.

Use this task to manage the Raman interface parameters.

Before you begin

Follow these steps to manage Raman interface parameters.

Procedure

  1. Click Optical Setup in the left panel.

  2. Click the ANS Parameters tab and then click Raman Interface to expand it.

  3. View the settings described in the following table. Only the Admin State parameter can be modified.

    Table 1. Interface Options

    Parameter

    Description

    Options

    Port

    (Display only) Displays the port number, port type, and direction (RX or TX)

    All the RX and TX ports

    Admin State

    Sets the administrative state of the port.

    From the drop-down list, choose one of the following:

    • Unlocked (ETSI)/ IS (ANSI)

    • Locked, disabled (ETSI)/OOS, DSBLD (ANSI)

    • Locked, maintenance (ETSI)/OOS, MT (ANSI)

    • Unlocked, automaticInService (ETSI)/ IS, AINS (ANSI)

    Service State

    (Display only) Identifies the autonomously generated state that gives the overall condition of the port. Service states appear in the format: Primary State-Primary State Qualifier, Secondary State.

    • IS-NR/

      Unlocked-enabled

    • OOS-AU,AINS/

      Unlocked-disabled,
automaticInService

    • OOS-MA,DSBLD/

      Locked-enabled,disabled

    • OOS-MA,MT/

      Locked-enabled,maintenance

    Optical Power (mW)

    (Display only) Displays the optical power for each port.

    -

    Current Optical Power Setpoint (mW)

    (Display only) Shows the current value of the optical power setpoint that must be reached.

    -

    Current Power Degrade High (mW)

    (Display only) Shows that the current value of the optical power degrade high threshold.

    Power Degrade High refers to the Signal Output Power value of the port and is automatically calculated by the control card.

    -

    Current Power Degrade Low (mW)

    (Display only) Shows that the current value of the optical power degrade high threshold configured in the card.

    Power Degrade Low refers to the Signal Output Power value of the port and is automatically calculated by the control card.

    -

    Current Power Failure Low (mW)

    (Display only) Shows the optical power failure low threshold for the port.

    -

  4. Click Apply to save the changes.

The manage Raman interface parameters task is complete.