Configuration Guide for Cisco Optical Site Manager, IOS XR Release 26.x.x

PDF

Configuration Guide for Cisco Optical Site Manager, IOS XR Release 26.x.x

Configure the administrative state of Pluggable Port Modules and line cards

Updated: October 14, 2026

Want to summarize with AI?

Log in

Use this procedure to configure the administrative state of Pluggable Port Modules and line cards in Cisco Optical Site Manager. It helps you complete the required configuration, verification, or management action and confirm the result.

Use this task to configure the administrative state of ports on Pluggable Port Modules (PPM) and line cards.

Pluggable port modules extend the port capacity of line cards in Cisco Optical Site Manager.

You can provision ports on PPM or line cards by setting their administrative state, which determines whether the ports are operational or shut down.

  • Administrative state changes take effect immediately after the configuration is applied.

Before you begin

Follow these steps to provision PPM ports or a line card in Cisco Optical Site Manager.

Procedure

  1. Click the Provisioning tab.

  2. Click the Pluggable Port Modules section to expand it.

  3. Click Edit.

    The fields in the table become editable.

  4. Select an administrative state from the Admin State column and click Apply.

    Alternatively, you can also right-click a PPM or a line card in the rack from the Topology page, and choose Change Admi State to change the administrative state.

The ports on the pluggable port module or line card become operational or non-operational based on the selected administrative state.