Configuration Guide for Cisco Optical Site Manager, IOS XR Release 26.x.x

Provision zr plus trail trace monitoring

Updated: October 14, 2026

Want to summarize with AI?

Use this procedure to provision ZR plus trail trace monitoring in Cisco Optical Site Manager. This task provisions the trail trace monitoring parameters that are supported for the ZR plus payloads on the 1.2T-MXP card.

Use this task to provision zr plus trail trace monitoring.

This task provisions the trail trace monitoring parameters that are supported for the ZR plus payloads on the 1.2T-MXP card.

Before you begin

Follow these steps to provision zr plus trail trace monitoring.

Procedure

Click the Provisioning > ZR Plus Trail Trace Monitoring tabs.

Modify any of the ZR Plus settings as described in the following table.

Table 1. ZR plus Trail Tracing Settings
Parameter	Description	Options
Port	(Display only) Displays the port number.	―
Send-Tti	Sets the transmit TTI String.	0-32 Bytes
Expected-Tti	Sets the expected TTI String.	0-32 Bytes
Received-Tti	(Display only) Displays the received TTI String.	0-32 Bytes

Note

When the trunk port is in OOS-DSBL state, its received TTI is not displayed in the GUI.

Click Apply.

The provision zr plus trail trace monitoring task is complete.

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.