Configuration Guide for Cisco Optical Site Manager, IOS XR Release 26.x.x

PDF

Configuration Guide for Cisco Optical Site Manager, IOS XR Release 26.x.x

Change Trunk Port Parameters

Updated: October 14, 2026

Want to summarize with AI?

Log in

Use this procedure to change Trunk Port Parameters. This task helps you complete the required configuration, verification, or management action in Cisco Optical Site Manager.

Adjust trunk port parameters to ensure proper configuration. You can enable or disable the port, set the frequency or wavelength, and optimize data transmission rates for network traffic and operational requirements.

Use this task to modify trunk port settings. Typically, you access these settings through management interfaces and adjust parameters such as administrative state, frequency, baud rate, and bits per symbol.

Before you begin

Log into Cisco Optical Site Manager

Follow these steps to configure the trunk port parameters.

Procedure

  1. Right-click a trunk port in the Rack, Chassis, or Card view and click Change Trunk Details.

    The Change Configuration dialog box is displayed.

  2. Select the Admin State to change the admin status of the trunk port to Out of Service or Automatic in Service.

  3. Enter or select the frequency in the Frequency field.

    The wavelength of the trunk port is automatically selected based on the frequency configured.

  4. Enter or select the Baud Rate or Bits Per Symbol.

    For more details about these fields, see Table 2

  5. Click Apply.

After changing the trunk port parameters and applying the configuration, the updated settings are saved and reflected in the system’s provisioning interface.