Explains the available card modes for modular line cards, their configuration options, and the impact each mode has on network operation and supported features.
This chapter lists the supported configurations and the procedures to configure the card mode on the line cards.
Unless otherwise specified, “line cards” refers to 1.2T and 1.2TL line cards.
1.2T line cards
This section explains the features, configurations, and port assignments of 1.2T line cards.
QXP cards
This section explains the features, operating modes, supported data rates, and configuration of QXP cards in the Cisco NCS 1014 system.
2-QDD-C line cards
This section explains the features, supported configurations, and key capabilities of the 2-QDD-C line cards used with NCS 1014.
2.4T, 2.4TX, and 2.4TA card modes
This section explains the characteristics and configuration modes for 2.4T, 2.4TX, and 2.4TA line cards, including trunk and client mappings, data rates, and muxponder modes.
Reset client optics remotely
Use this procedure to configure and run a CLI command to perform a remote cold reset of supported client optics for troubleshooting or management.