Cisco APIC Layer 2 Networking Configuration Guide, Release 6.2(x)

IP-EPG configuration verification using switch commands

Updated: July 7, 2026

Want to summarize with AI?

Lists switch commands used to verify IP-EPG ("IpCkt") configurations and their expected outputs.

This reference explains how to use switch commands to verify IP-EPG ("IpCkt") configurations.

Switch troubleshooting commands

The following commands verify IP-EPG configurations:


cd /mits/sys/ctx-vxlan.../bd-vxlan...
     - cat summary
vsh -c "show system internal epm vlan all" or
vsh -c "show vlan internal bd-info"
vsh -c "show system internal epm vlan <vlan-id> detail"
vsh -c "show system internal epm endp ip <a.b.c.d>"
vsh_lc -c "show system internal epm vlan all" or
vsh_lc -c "show vlan internal bd-info"
vsh_lc -c "show system internal epm vlan <vlan-id> detail"
vsh_lc -c "show system internal epm endp ip <a.b.c.d>"
vsh_lc -c "show system internal epm epg"

Note

"IpCkt" and "IP-EPG" are used interchangeably in this document.

Note

The VLAN ID can be found through any of the show vlan internal bd-info commands or through the show system internal epm vlan all command.

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.