Configure the port track feature using the () GUI.
This procedure uses the () GUI to configure the port track feature.
Follow these steps to configure fabric port tracking using the GUI:
Cisco APIC Layer 2 Networking Configuration Guide, Release 6.2(x)
Is this content helpful?
Thank you for your feedback. Your response has been recorded.
AI responses are currently only available to logged in users. Log in
Only ask questions about this document. To ask questions about this product as a whole, go to Technical Documentation .
Suggestions
Sorry, we couldn't generate a response for this query.
Cisco APIC Layer 2 Networking Configuration Guide, Release 6.2(x)
Updated: July 7, 2026
Want to summarize with AI?
Log inConfigure the port track feature using the () GUI.
This procedure uses the () GUI to configure the port track feature.
Follow these steps to configure fabric port tracking using the GUI:
On the menu bar, choose System > System Settings.
In the Navigation pane, choose Port Tracking.
For the Port tracking state parameter, choose on to enable fabric port tracking.
For the Delay restore timer parameter, specify the time in seconds.
This parameter determines how long the leaf node will wait before bringing up its downlink ports after the fabric port status and infra ISIS adjacencies are restored.
Configure the Number of active fabric ports that triggers port tracking parameter.
When the number of operational fabric ports on a leaf node is decreased to the configured number or lower, the leaf node will bring down its downlink ports.
Put a check in the Include APIC ports when port tracking is triggered checkbox.
Enabling this parameter brings down the downlink ports that are connected to the Cisco APICs as well as downlink ports for user traffic when port tracking is triggered. This option should not be checked unless the Cisco APIC is connected to two different leaf nodes for high availability.
Need help?
(Requires a Cisco Service Contract)
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.