Cisco APIC Layer 2 Networking Configuration Guide, Release 6.2(x)

PDF

Cisco APIC Layer 2 Networking Configuration Guide, Release 6.2(x)

View Statistics for Isolated Endpoints on Cisco ACI Virtual Edge Under the Tenants Tab

Updated: July 7, 2026

Want to summarize with AI?

Log in

View statistics for isolated endpoints that you have configured on a Cisco ACI Virtual Edge using the Cisco APIC Tenants tab.

If you configured intra-EPG isolation on a Cisco ACI Virtual Edge, once you have chosen statistics for the endpoints, you can view them.

Before you begin

You must have chosen statistics to view for isolated endpoints. See View Statistics for Isolated Endpoints on Cisco ACI Virtual Edge Under the Tenants Tab in this guide for instructions.

Follow these steps to view statistics for isolated endpoints on Cisco ACI Virtual Edge under the Tenants tab:

Procedure

  1. Log in to Cisco APIC.

  2. Choose Tenants > tenant.

  3. In the tenant navigation pane, expand the Application Profiles, profile, and Application EPGs folders, and then choose the EPG containing the endpoint with statistics that you want to view.

  4. In the EPG Properties work pane, click the Operational tab to display the endpoints in the EPG.

  5. Double-click the endpoint with statistics that you want to view.

  6. In the Properties work pane for the endpoint, click the Stats tab.

    The work pane displays the statistics that you chose earlier. You can change the view by clicking the table view or chart view icon on the upper left side of the work pane.