Describes SAN port channels as logical interfaces that aggregate Fibre Channel interfaces to improve bandwidth utilization and availability. These interfaces facilitate optimal connectivity between Cisco ACI switches and Fibre Channel core switches.
A SAN port channel is a logical interface that combines a set of FC interfaces connected to the same Fibre Channel node and operates as one link.
-
Supports bandwidth utilization and availability.
-
Connects to FC core switches.
-
Provides transparent failover between the uplinks of a VSAN.
SAN port channel guidelines and modes
Guidelines for configuring SAN port channels include the following:
-
The maximum number of active port channels (SAN port channels plus VFC uplink/NP port channels) on the Cisco ACI switch is seven. Any additional configured port channels remain in the errdisabled state until you shut or delete one of the existing active port channels. After you shut/delete an existing active port channel, shut/no shut the errdisabled port channel to bring it up.
-
The maximum number of FC interfaces that can be combined into a SAN port channel is limited to 16.
-
The default channel mode on Cisco ACI switches for SAN port channels is active ; this cannot be changed.
-
When a SAN port channel is connected to a Cisco FC core switch, only channel mode active is supported. Channel mode active must be configured on the Cisco FC core switch.
Regarding SAN port channel modes, a SAN port channel is configured with channel mode active by default. When active, the member ports initiate port channel protocol negotiation with the peer port regardless of the channel-group mode of the peer port. If the peer port, while configured in a channel group, does not support the port-channel protocol, or responds with a nonnegotiable status, the port channel is disabled. The active port channel mode allows automatic recovery without explicitly enabling and disabling the port-channel-member ports at either end.