Cisco APIC Layer 2 Networking Configuration Guide, Release 6.2(x)

PDF

Cisco APIC Layer 2 Networking Configuration Guide, Release 6.2(x)

Configuring Intra-EPG Isolation for VMware VDS or Microsoft Hyper-V Virtual Switch using the GUI

Want to summarize with AI?

Log in

Configures intra-EPG isolation for VMware VDS or Microsoft Hyper-V virtual switches within the Cisco APIC GUI. This process enables enforced isolation for application EPGs to enhance network security.


Bronx QA: Broke out this topic and updated it at team's request.

EBRO: Revised title to reflect support for Microsoft vSwitch. Tweaking procedure based on the GUI, and noted issue. ~ catortiz 7/5/17.

Procedure

  1. Log into Cisco APIC.

  2. Choose Tenants > tenant .

  3. In the left navigation pane expand the Application Profiles folder and appropriate application profile.

  4. Right-click the Application EPGs folder and then choose Create Application EPG .

  5. In the Create Application EPG dialog box, complete the following steps:

    1. In the Name field, add the EPG name.
    2. In the Intra EPG Isolation area, click Enforced .
    3. In the Bridge Domain field, choose the bridge domain from the drop-down list.
    4. Associate the EPG with a bare metal/physical domain interface or with a VM Domain.
      • For the VM Domain case, check the Associate to VM Domain Profiles check box.

      • For the bare metal case, check the Statically Link with Leaves/Paths check box.

    5. Click Next .
    6. In the Associated VM Domain Profiles area, click the + icon.
    7. From the Domain Profile drop-down list, choose the desired VMM domain.

      For the static case, in the Port Encap (or Secondary VLAN for Micro-Seg) field, specify the secondary VLAN, and in the Primary VLAN for Micro-Seg field, specify the primary VLAN. If the Encap fields are left blank, values will be allocated dynamically.

      Note
      For the static case, a static VLAN must be available in the VLAN pool.
  6. Click Update and click Finish .