Overview
Instructions for deploying an existing Catalyst Center HA cluster, where the primary node uses nonstandard interface configurations.
To deploy an existing HA cluster where the primary node uses nonstandard interface configurations, complete these steps.
Procedure
| 1. | Upgrade the primary node to the latest release of Catalyst Center. For information about upgrading your current release of Catalyst Center, see the Cisco Catalyst Center Upgrade Guide. |
|
| 2. | Create a backup of the remote repository. See the "Backup and Restore" chapter in the Cisco Catalyst Center Administrator Guide. |
|
| 3. | Reimage the primary node with the required interface cable configuration. See Interface cable connections and Install the Catalyst Center ISO image. Ensure that the VIP has been configured correctly on the primary node. |
|
| 4. | Install the same set of packages on the primary node that you selected during the backup. |
|
| 5. | Using the backup file that you created in Step 2, restore the remote repository's data. |
|
| 6. | Configure the second and third appliances in the cluster.
|