Cisco Catalyst Center Third-Generation Appliance Installation Guide, Release 3.1.x
Is this helpful?
Thank you for your feedback. Your response has been recorded.
AI responses are currently only available to logged in users.Log in
Important. Results generated by AI. Before using results, verify accuracy and completeness.
Only ask questions about this document. To ask questions about this product as a whole, go to Technical Documentation .
Suggestions
Sorry, we couldn't generate a response for this query.
Launch error Something went wrong. Please try again.
Table of contents
Updated: April 3, 2026
Want to summarize with AI?
Log inImportant. Results generated by AI. Before using results, verify accuracy and completeness.
Provides a pointer to the steps you need to complete after reimaging your Catalyst Center appliance.
When the installation of the Catalyst Center ISO image completes, the installer reboots and opens the Maglev Configuration wizard's welcome screen. To finish the reimaging of your appliance, complete the steps described in Configure the Appliance Using the Maglev Wizard.
(Requires a Cisco Service Contract)
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.