Routing Configuration Guide, Cisco Catalyst SD-WAN Releases 17.x

Verify MSDP configuration to interconnect Cisco SD-WAN and Non-SD-WAN

Updated: February 6, 2026

Want to summarize with AI?

Overview

Use this procedure to confirm that protocol interoperability is active and that remote nodes are correctly identified within the overlay.

Procedure

The following is a sample output from the show platform software sdwan multicast remote-nodes vrf 1 command, which shows if MSDP interoperability is enabled or not.

Example:

Device# show platform software sdwan multicast remote-nodes vrf 1
            Multicast SDWAN Overlay Remote Nodes (* - Replicator, ^ - Delete Pending):
            Received                Sent
            SPT-Only MSDP             (X,G)      (S,G)      (X,G)      (S,G)
            System IP   Mode     I-Work Label  Join/Prune Join/Prune Join/Prune Join/Prune
            10.16.255.11 No       No     1003      0/0        0/0        0/0        1/0
            10.16.255.15 No       No     1003      1/0        1/0        0/0        0/0
            10.16.255.16 Yes      No     1003      1/0        1/0        0/0        0/0
            10.16.255.21 Yes      Yes    1003      0/0        0/0        0/0        0/0

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.