Routing Configuration Guide, Cisco IOS XE Catalyst SD-WAN Release 17.x

Verify a transport gateway configuration using the CLI

Updated: March 9, 2026

Want to summarize with AI?

Overview

Validates that a device is actively functioning as a transit hub by checking the running configuration and OMP status.

Procedure

Use the show sdwan running-config system command on a device to check whether it is configured as a transport gateway. In the output, transport-gateway enable indicates that it is configured.

Device#show sdwan running-config system
system 
system-ip            192.168.1.1
domain-id            1
site-id              11100
region 1
!
role                 border-router
transport-gateway enable
...

You can also use the show sdwan omp summary command on a device to check whether it is configured as a transport gateway. In the output, transport-gateway enabled indicates that transport gateway functionality is enabled.

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.