Routing Configuration Guide, Cisco Catalyst SD-WAN Releases 17.x

Configure MSDP to interconnect Cisco SD-WAN and Non-SD-WAN using a CLI Template

Updated: February 6, 2026

Overview

Use this procedure to enable protocol interworking and define specific VRF parameters using a command-line template.

Before you begin

Note

You cannot configure the MSDP interoperability using the feature template or the configuration groups in Cisco SD-WAN Manager.

Procedure

Enable MSDP on Cisco IOS XE Catalyst SD-WAN device. For more information, see Configure MSDP Using a CLI Template.

Configure MSDP interworking using a CLI template.

Note

By default, CLI templates execute commands in global config mode.

Enable MSDP on a Cisco IOS XE Catalyst SD-WAN device. For more information, see Configure MSDP Using a CLI Template

Configure a Cisco IOS XE Catalyst SD-WAN device for MSDP interoperability with other devices in the non-SD-WAN sites.

multicast address-family ipv4 vrf vrf-name 
spt-only 
msdp-interworking

Example:

The following is a complete configuration example to configure MSDP interoperability in Cisco Catalyst SD-WAN:

sdwan                                                                                                                                  
 multicast address-family ipv4 vrf 1                                                                                            
  spt-only                                                                                                                                                                                                      
  msdp-interworking

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.