Cisco Ultra-Reliable Wireless Backhaul Standalone, Software Configuration Guide, Release 26.2.x

Configure VLAN SETTINGS

Updated: September 28, 2026

Want to summarize with AI?

Configure VLAN SETTINGS to connect the access point to a VLAN that is part of the local wireless network.

Configure VLAN SETTINGS to enable the access point to connect to VLANs within the local wireless network using specific management and native VLAN identifiers.

Default VLAN configuration parameters for the access point are:


Parameter	Default value
Management VLAN ID (MVID)	1
Native VLAN ID (NVID)	1

Procedure

In the ADVANCED SETTINGS, click VLAN SETTINGS.

The VLAN SETTINGS window appears.
Check the Enable VLANs checkbox to connect the access point to a VLAN that is part of the local wireless network.
Enter the management identification number of the VLAN in the Management VLAN ID field.

For detailed info about VLAN SETTINGS and packet management, see Rules for Packet Management.

Note

The same Management VLAN ID must be used on all the access points that are part of the same mesh network.
Enter the native identification number of the VLAN in the Native VLAN ID field.
Click Save.

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.