Cisco Ultra-Reliable Wireless Backhaul Standalone, Software Configuration Guide, Release 26.2.x
Is this content helpful?
Thank you for your feedback. Your response has been recorded.
AI responses are currently only available to logged in users. Log in
Only ask questions about this document. To ask questions about this product as a whole, go to Technical Documentation .
Suggestions
Sorry, we couldn't generate a response for this query.
Cisco Ultra-Reliable Wireless Backhaul Standalone, Software Configuration Guide, Release 26.2.x
Updated: September 28, 2026
Want to summarize with AI?
Log inConfigure NAPT functionality to enable downstream data flow on the AP using CLI commands.
Configure NAPT functionality to enable downstream data flow on the AP.
Perform this task to configure NAPT functionality to enable downstream data flow on the AP.
Use the configure ip nat enable command to enable the NAT rules on the AP.
Device# configure ip nat enableNoteYou can use the configure ip nat disable command to disable the NAT configuration on the AP.
Use the configure ip nat inside ipv4 ipv4-address netmask command to configure inside IPv4 address on the NAT.
Device# configure ip nat inside ipv4 192.168.70.2 255.255.255.0Use the configure ip nat inside port range first-port-number second-port-number command to configure inside port range on the NAT.
Device# configure ip nat inside port range 32000 33000The valid range for the inside port is 1 to 35000. This range must not overlap with the SNAT port range. By default, the minimum port value is 30000 and the maximum is 35000. The minimum configurable value for both ranges is 1.
Use the configure ip nat entry add proto{ TCP| UDP} outside port outside-port-number inside ipv4 inside-ipv4-address port inside-port-number command to configure protocol, outside port value, inside IPv4 address, and inside port value on the NAT.
Device# configure ip nat entry add proto TCP outside port 38080 inside ipv4 192.168.0.2 port
8080Use the write command to save the current configuration.
Device#writeUse the reload command to reload the device.
Device#reloadNeed help?
(Requires a Cisco Service Contract)
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.