Cisco Ultra-Reliable Wireless Backhaul Standalone, Software Configuration Guide, Release 26.2.x
Is this content helpful?
Thank you for your feedback. Your response has been recorded.
AI responses are currently only available to logged in users. Log in
Only ask questions about this document. To ask questions about this product as a whole, go to Technical Documentation .
Suggestions
Sorry, we couldn't generate a response for this query.
Cisco Ultra-Reliable Wireless Backhaul Standalone, Software Configuration Guide, Release 26.2.x
Updated: September 28, 2026
Want to summarize with AI?
Log inConfigures the URWB telemetry protocol to transmit raw UDP data to a specified receiver. This procedure establishes the server destination and enables the export functionality for telemetry data.
By default, the telemetry data is disabled.
Use the configure telemetry server dest-ip port command to set the IP address and UDP port of the receiver.
Device# configure telemetry server 10.115.11.56 1234Multicast addresses are supported.
Use the configure telemetry export { enable | disable } command to enable raw UDP telemetry transmission to the configured server.
Device# configure telemetry export enable Note
Ensure the IP address is configured before you rune the configure telemetry export enable command. If not, the command rejects with an error please configure the telemetry server IP first.
The IP server is simultaneously set to 0.0.0.0 (the port value is unchanged) when you execute the configure telemetry export disable command.
Use the show telemetry config command to verify telemetry configuration.
Device# show telemetry config
Telemetry export: enabled, current (live): disabled
Telemetry server: 10.115.11.56 1234, current (live): 0.0.0.0 30000Need help?
(Requires a Cisco Service Contract)
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.