Cisco Ultra-Reliable Wireless Backhaul Standalone, Software Configuration Guide, Release 26.2.x

PDF

Cisco Ultra-Reliable Wireless Backhaul Standalone, Software Configuration Guide, Release 26.2.x

Configure point-to-point relay topology from CLI

Updated: September 28, 2026

Want to summarize with AI?

Log in

Configure a point-to-point relay topology using CLI commands to set up wireless device interfaces with specific radio settings and operating modes.

This task configures a point-to-point relay topology for wireless devices to establish communication links between mesh endpoints and mesh points using CLI commands.

Point-to-point relay topology configuration involves setting up wireless interfaces with specific radio configurations, operating modes, and channel assignments for mesh networks.

Procedure

  1. Use the configure dot11Radio interface command to configure the wireless device with radio interface number.

    Example:

    Device# configure dot11Radio 1

  2. Use the configure dot11Radio interface {enable | disable} command to set wireless interface admin state to enable or disable mode.

    Example:

    Device# configure dot11Radio 1 enable

  3. Use the configure dot11Radio interface {enable | disable}mode {fluidity | fixed| fluidmax} command to configure an operating mode for the specified interface (fixed or Fluidity or Fluidmax).

    Example:

    Device# configure dot11Radio 1 enable mode fluidity

  4. Use the configure dot11Radio interface {enable | disable}mode {fluidity | fixed| fluidmax}channel channel id Set the operating channel for the specified interface and the operating channel id valid range is between 1 to 256.

    Example:

    Device# configure dot11Radio 1 enable mode fluidity channel 10

  5. End the configuration.

    Example:

    Device# end

Configuration examples

Basic configuration example:

Device#configure dot11Radio <2> {enable | disable} mode {fluidity} channel <36>

Mesh End (ME) Configuration

Device#configure dot11Radio 2 enable
Device#configure dot11Radio 2 mode fixed
Device#configure dot11Radio 2 channel 36

Mesh Point (MP1) Configuration

Device#configure fluidity id infrastructure
Device#configure dot11Radio 1 enable
Device#configure dot11Radio 1 mode fixed
Device#configure dot11Radio 1 channel 36
Device#configure dot11Radio 2 enable
Device#configure dot11Radio 2 mode fixed
Device#configure dot11Radio 2 channel 149

MP2 Configuration

Device#configure fluidity id infrastructure
Device#configure dot11Radio 1 enable
Device#configure dot11Radio 1 mode fixed
Device#configure dot11Radio 1 channel 149