Configure Web UI access on a device using CLI commands.
Enable Web UI access to allow graphical interface management of the device.
Web UI access provides a graphical interface for device management and configuration.
Cisco Ultra-Reliable Wireless Backhaul Standalone, Software Configuration Guide, Release 26.2.x
Is this content helpful?
Thank you for your feedback. Your response has been recorded.
AI responses are currently only available to logged in users. Log in
Only ask questions about this document. To ask questions about this product as a whole, go to Technical Documentation .
Suggestions
Sorry, we couldn't generate a response for this query.
Cisco Ultra-Reliable Wireless Backhaul Standalone, Software Configuration Guide, Release 26.2.x
Updated: September 28, 2026
Want to summarize with AI?
Log inConfigure Web UI access on a device using CLI commands.
Enable Web UI access to allow graphical interface management of the device.
Web UI access provides a graphical interface for device management and configuration.
To enable Web UI access, use the following command:
Device# configure webui enableTo verify whether web UI access is enabled, use the following command:
Device# show webui config
Web-UI: enabledNeed help?
(Requires a Cisco Service Contract)
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.