Cisco Ultra-Reliable Wireless Backhaul Standalone, Software Configuration Guide, Release 26.2.x

Delete multicast using CLI

Updated: September 28, 2026

Want to summarize with AI?

Configure the system to remove a meshID IP address from a multicast group using CLI commands.

This task removes a specific meshID IP address from a multicast group configuration using the command line interface.

Use this procedure when you need to remove a meshID IP address from an existing multicast group configuration. This is typically done during network reconfiguration or when decommissioning specific network segments.

Procedure

Use the configure multicast group delete multicast IP-address netmask meshID IP-address command to delete the meshID IP address from the multicast group.

Example:

Device# configure multicast group delete 224.5.5.5 255.255.255.255 5.255.255.255

Note

This configuration takes effect only after the reboot.

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.