Cisco Ultra-Reliable Wireless Backhaul Standalone, Software Configuration Guide, Release 26.2.x

Configure Rx-SOP threshold from CLI

Updated: September 28, 2026

Want to summarize with AI?

Configure receiver start of packet (Rx-SOP) threshold using CLI commands.

Configure the receiver start of packet (Rx-SOP) threshold to control signal detection sensitivity on the wireless interface.

The Rx-SOP threshold setting determines the minimum signal level required for the receiver to detect the start of a packet.

Procedure

Configure the Rx-SOP threshold using the following CLI command:

Example:

Device# configure dot11radio <interface> rx-sop-threshold

<0 - 91> Enter rx-SOP- threshold (0: AUTO, VALUE: -VALUE dBi).

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.