Cisco APIC Layer 3 Networking Configuration Guide, Release 6.2(x)

Configure dataplane IP address learning per VRF instance using the GUI

Updated: April 17, 2026

Want to summarize with AI?

Configures dataplane IP address learning settings for a specific VRF instance. This procedure allows administrators to enable or disable the learning process within the tenant networking configuration.

This section explains how to disable dataplane IP address learning per VRF instance.

The following procedure assumes that you have already configured a tenant and VRF instance.

Procedure

Navigate to Tenants > tenant_name > Networking > VRFs > vrf_name .
On the VRF - vrf_name work pane, click the Policy tab.
Scroll to the bottom of the Policy work pane and locate IP Data-plane Learning .
Click one of the following:
- Disabled : Disables dataplane IP address learning on the VRF instance.
- Enabled : Enables dataplane IP address learning on the VRF instance.
Click Submit .

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.