Install and connect

This section describes the installation procedure for C8475-G2 and C8455-G2 in an equipment rack.

• Two-post rack, either 19 inch or 23 inch. Inner clearance (the width between the inner sides of the two posts or rails) must be at least 19 inches (48.26 cm) or 23 inches (58.42 cm). Airflow through the chassis is from front to back (I/O-side to PSU-side).

• (Only supported on C8475-G2) Four-post, 19-inch equipment rack. Inner clearance (the width between the inner sidesof the two posts or rails) must be at least 19 inches (48.26 cm). Airflow through the chassis is from front to back.

Do not unpack the device until you are ready to install it. If the final installation site will not be ready for some time, keep the chassis in its shipping container to prevent accidental damage. When you are ready to install the chassis, proceed with unpacking it.

The chassis, accessory kit, publications, and any optional equipment you ordered may be shipped in more than one container. When you unpack the containers, check the packing list to ensure that you received all of the items on the list.

Before installing and connecting a Cisco 8400 Series Secure Router, read the safety warnings and gather the tools and equipment. See the Required Tools and Equipment for Installation and Maintenance section, for more information about the required tools and equipment.

Use the USB or RJ-45 console port on the router to access the Cisco Internet Operating System (IOS-XE) and IOS XE SD-WAN command line interface (CLI) on the router and perform configuration tasks. A terminal emulation program is required to establish communication between the router and a PC. See the Connect to a Console Terminal or Modem section in this document for instructions.

Note

A Microsoft Windows USB driver must be installed before you establish physical connectivity between the router and the PC.