ILA node configuration

Updated: June 17, 2026

Want to summarize with AI?

This section provides details about configuring an ILA node for Cisco NCS 1010. Use it to review the command example and settings that support remote node management.

Use this reference to review configure ILA node.

The following information supports configure ILA node:

The following is a sample command for ILA node configuration:


interface GigabitEthernet0/0/0/0
ipv4 address 10.8.1.21 255.255.255.0
!         
interface GigabitEthernet0/0/0/2
ipv4 address 10.7.1.21 255.255.255.0

router ospf 1
distribute link-state
network point-to-point
redistribute connected
area 0
  interface Loopback0
  !
  interface GigabitEthernet0/0/0/0
  !
  interface GigabitEthernet0/0/0/2

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.