Use this procedure to configure daisy chain on management ports so that Cisco NCS 1010 nodes can support management connectivity.
Configure daisy chain on management ports so that Cisco NCS 1010 uses the required settings for the selected system setup, management, or routing workflow.
To configure IP Address on management port 0, use these commands:
Before you begin
The following prerequisites must be met before configuring Daisy Chain on NCS1010:
-
Enable Storm Control on Switch.
-
STP must be running on the TOR switch.
-
Daisy chain must be enabled on all the NCS1010 devices in the topology.
Configuring Daisy Chain on managements ports of NCS 1010 devices involves the following tasks:
Configure IP Address on Management Port
interface type Rack/Slot/Instance/Port
ipv4 address ip-address
Configure Daisy Chain
interface type Rack/Slot/Instance/Port
no ipv4 address
no ipv6 address
bridge-port routed-interface typeRack/Slot/Instance/Port
Before you begin
Follow these steps to configure daisy chain on management ports:
Procedure
Run the configure command to enter configuration mode. |
The system completes the configure daisy chain on management ports task.