Configuration Guide for Cisco NCS 1001, IOS XR Release 25.x.x

Stop OTDR measurement

Updated: July 27, 2026

Want to summarize with AI?

Use this procedure to stop an OTDR measurement that is running in automatic or expert mode and verify that the scan is stopped.

Stop an OTDR measurement when the current scan must be canceled.

The same abort command applies to automatic and expert modes.

Procedure

Stop the OTDR scan for the selected slot and port.

hw-module slot slot-number otdr port port-number scan abort

Example:

hw-module slot 3 otdr port 1 scan abort

Use the show hw-module command to display OTDR status to verify the abort state.

Example:

show hw-module slot 3 otdr status

Port | Rx/Tx | Date/Time       | Training | OTDR Measurement | Next scan (min)
-----+-------+-----------------+----------+------------------+----------------
  1  |  Tx   | 20190927-102727 | ABORTED  | UNKNOWN          | 0

Example:

show hw-module slot 3 otdr status

Port | Rx/Tx | Date/Time       | Training | OTDR Measurement
-----+-------+-----------------+----------+-----------------
  1  |  Tx   | 20180503-181159 | UNKNOWN  | ABORTED

The selected OTDR measurement is stopped.

Need help?

Open a support case

(Requires a Cisco Service Contract)

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.