Describes how to install and remove a Cisco transceiver module.
This section describes how to install and remove Cisco transceiver modules.
Remove Cisco-pluggable transceiver modules
Procedure
| 1. | Attach an ESD-preventive wrist strap to your wrist and to an earth ground surface. |
|
| 2. | Disconnect the cable from the transceiver module. For reattachment, note which cable connector plug is send (TX) and which is receive (RX). |
|
| 3. | Insert a dust plug into the optical ports of the transceiver module to keep the optical interfaces clean. |
|
| 4. | If the transceiver module has a bale-clasp latch, pull the bale out and down to eject the module. If you cannot use your finger to open the latch, use a small, flat-blade screwdriver or other long, narrow instrument to open it. |
|
| 5. | Grasp the transceiver module, and carefully remove it from the slot. |
|
| 6. | Place the transceiver module in an antistatic bag or other protective environment. |