Cisco Catalyst SD-WAN Policies Configuration Guide, Releases 26.x and Later

PDF

Cisco Catalyst SD-WAN Policies Configuration Guide, Releases 26.x and Later

Configuration verification for Equinix service insertion

Updated: April 24, 2026

Want to summarize with AI?

Log in

Provides methods to verify service chain configurations after instantiation in Cisco SD-WAN.

  • After you instantiate the service chain, you can view the service chain instances in Configuration > Service Insertion. This page displays a list of service chain instances along with the Cisco IOS XE Catalyst SD-WAN device attached to each service chain instance.

  • To view the details of the device that is attached to the service chain instance, click the device in the Attached to column. You can use the information about service TX and RX interfaces and the IP addresses on the Cisco SD-WAN Manager for the configurations on the Palo Alto Networks Firewall. Configure the service TX IP address on the service TX interface, and the service RX IP address on the service RX interface on the Palo Alto Networks Firewall.

  • To view details such as service type, password, IP address, and so on, of the service used in the service chain instance, click the Number of Services option.