Outlines the limitations and usage constraints of performance monitoring.
Performance monitoring is only supported on IPv4 traffic. IPv6 traffic is not supported.
Once a performance monitor is applied to a device, the configuration cannot be modified and reapplied to the device. Follow these steps to make any modifications to performance monitor configuration:
-
Edit the CLI Add-on feature template or device CLI template to remove the performance monitor apply command from the template. Update the device CLI template or the device template to which the CLI Add-on feature template is attached.
-
Edit the performance monitor context in the CLI Add-on feature template, and apply the performance monitor again using the performance monitor apply command. Update the device template to which the CLI Add-on feature template is attached.
Alternatively, configure a new context based on the same monitoring profile, and remove the previous context configuration.
App visibility must be enabled in a policy to be able to set the connector initiator value appropriately.