Describes how to configure and monitor the system health check service on Cisco NCS 1014, including enabling the service, changing the refresh time, customizing metric thresholds, viewing metric status, and disabling health check.
Monitoring systems in a network proactively helps prevent potential issues and take preventive actions. This chapter describes the tasks to configure and monitor system health check.
System health checks
Describes how the Cisco NCS 1014 health check service monitors physical characteristics, processing status, and resource utilization to help you assess the device condition and identify potential issues before they impact the network.
Enable the health check
Configure the health check service on Cisco NCS 1014 by enabling the service and the Network Configuration Protocol (NETCONF) and Google Remote Procedure Call (gRPC) agents so that you can monitor system health.
Health check refresh cadence
Explains how to adjust the cadence at which the health check status is refreshed on Cisco NCS 1014 so that the system reports metric updates at the interval that suits your monitoring requirements.
View the status of all metrics
Verify the status of all supported health check metrics on Cisco NCS 1014, including configured thresholds, health check manager state, and the current health state of each enabled metric.
Metric threshold values
Explains how to customize the health check threshold value for a specific metric on Cisco NCS 1014 so that the system raises alerts at resource usage levels that match your operational requirements.
View health status of an individual metric
View the health status of a specific system resource or infrastructure service metric on Cisco NCS 1014.
Disable health check
Configure Cisco NCS 1014 to disable the entire health check service or turn off health checks for individual metrics as required.