Describes the verification checks that you must perform after you log in to the Cisco NCS 1014 console so that you can confirm the default setup and correct any issue before further configuration.
Preliminary checks for Cisco NCS 1014
Describes the verification checks that you must perform after you log in to the Cisco NCS 1014 console so that you can confirm the default setup and correct any issue before further configuration.
Verify hardware components status
Verify the operational state of every hardware component on Cisco NCS 1014 by running the show platform and show inventory commands.
Verify the software version
Verify the Cisco IOS XR software version that is installed on Cisco NCS 1014 by running the show version command.
Verify environmental parameters
Verify the environmental parameters of the Cisco NCS 1014 chassis, including fan speed, power, temperature, voltage, and current.
Verify management interface status
Verify the configuration and operational status of the management Ethernet interface on Cisco NCS 1014 using the appropriate show commands.
Verify firmware version
Verify the field-programmable device (FPD) firmware version running on each hardware component of Cisco NCS 1014 using the show hw-module fpd and show fpd package commands.
Display alarms on Cisco NCS 1014
Verify the alarms active on Cisco NCS 1014 by displaying them with the appropriate show alarms command.
Verify core dump context information
Verify the latest core dump context information for any process on Cisco NCS 1014 using the show context command.
Verify core files
Verify whether any process has generated compressed core dump files on the hard disk of Cisco NCS 1014.