Configure the console connection and boot process required to start Cisco NCS 1014 and create the root-system username.
Boot the Cisco NCS 1014 system and complete the initial setup through the console port.
Use the console port to connect to Cisco NCS 1014. By default, the console port connects to XR mode. Once the management port is configured, you can use it for subsequent connections.
Procedure
| 1. | Connect a terminal to the console port of the RP. |
|
| 2. | Start the terminal emulation program on your workstation. The console settings are 115200 bps for NCS1K14-CNTLR-K9, 9600 bps for NCS1K14-CTLR-B-K9, 8 data bits, 1 stop bit, and no parity. |
|
| 3. | Power on the Cisco NCS 1014. To power on the shelves, install the AC or DC power supplies and cables. As Cisco NCS 1014 boots up, you can view the boot process details at the console of the terminal emulation program. |
|
| 4. | Press Enter. The boot process is complete when the system prompts you to enter the root-system username. If the prompt does not appear, wait for a while to give Cisco NCS 1014 more time to complete the initial boot procedure; then press Enter.
|
Cisco NCS 1014 completes the boot process and prompts you to create the root-system username for logging on to the XR console.