Lists the network interface allocations, IP address assignments, and recommended configurations for cloud-hosted SD-WAN control components.
Network interface allocation for SD-WAN control components
For SD-WAN Manager instances, we allocate three network interfaces: eth0, eth1, and eth2.
For SD-WAN Validator and SD-WAN Controller instances, we allocate two network interfaces: eth0 and eth1.
Public and private IP addresses assigned to the network interfaces remain static. If you replace or move an SD-WAN control component instance to a new region, these addresses may change.
You can view the static IP address using the Catalyst SD-WAN Portal, from .
Recommended interface configurations
| Control Component |
Network interface 1 (eth0) |
Network interface 2 (eth1) |
Network interface 3 (eth2) |
|---|---|---|---|
| Management access |
Control access by nodes in fabric |
Communication among SD-WAN Manager instances in a cluster; SD-AVC component functionality |
|
| SD-WAN Manager |
Private IP Static pre-assigned address (Refer to Note 1.) Public IP Static pre-assigned address One-to-one NAT mapping to private IP address Configuration requirements
|
Private IP Static pre-assigned address Public IP Static pre-assigned address One-to-one NAT mapping to private IP address Configuration requirements
|
Private IP Static pre-assigned address Public IP None assigned Configuration requirements
|
| SD-WAN Validator |
Use the same configuration as for SD-WAN Manager. |
Use the same configuration as for SD-WAN Manager. |
Not applicable. |
| SD-WAN Controller |
Use the same configuration as for SD-WAN Manager. |
Use the same configuration as for SD-WAN Manager. |
Not applicable. |
1: A cloud gateway deployed using the Catalyst SD-WAN Portal can access this address. For details, refer to the Custom IP prefixes for cloud-hosted SD-WAN control components section in this guide.
2: The interface always receives the same private IP on every DHCP renewal, even when DHCP is used for IP assignment.